Preset Tuning - Teac AG-D8900 Manual Del Usuario

Preset Tuning

This facility is used to store FM, AM broadcasting from
Channel 1 to 30 respectively.
Automatic Memory Presetting
1
POWER ON
1. Select the TUNER function.
2. Select the AM or FM by pressing the BAND selector
button.
3. Press the MEMORY button for a while (for more than
1.5 seconds).
1 The start frequency will show in the display.
87.5 MHz in FM, 522 kHz in AM.
2 The frequency and display will automatically scan.
50 kHz steps for FM, 9 kHz steps for AM.
3 The frequency shown in the display will rapidly
change. As each station is located a preset
number will appear in the display indicating which
preset MEMORY button has been assigned to the
station located. The scanning process will
continue to operate in this fashion until 30
stations have been found and entered into the
preset memory or when there are no more
stations to be found on the waveband chosen.
The memory indicator will extinguish and let you
hear the last station to be memorized.
To listen to the memorized station select the band
required and press the numeric keys 1, 2, 3 etc.
4. The last memorized channel of each band will be
displayed when Auto Memory is completed. Check
the programmed frequencies with TUNING/PRESET
UP, DOWN button.
4 2
1. Select the TUNER function.
2. Select the AM or FM by pressing the BAND selector
3
3. Press the MODE button to change to TUNING mode.
4. Select the frequency you want to preset by pressing
5. Press the MEMORY button briefly, MEMORY display
6. While the MEMORY indicator is lit, press the numeric
– 13 –
Manual Memory Presetting
1 6
POWER ON
button.
(The PRESET CH. indicator disappears from the
display.)
TUNING/PRESET UP or DOWN button.
will blink at an interval of 1 second.
key(s) to input the channel number in which the data
(AM or FM band and frequency) for the broadcast is
to be stored (or press the TUNING/PRESET button
then press the MEMORY button again).
2
5 3 4, 6