Appendix - Grundfos CIM 500 Instrucciones De Instalación Y Funcionamiento

Appendix

Webserver configuration
The built-in webserver offers easy monitoring of the CIM 500 module and makes it possible to configure the
selected Industrial Ethernet protocol. Using the webserver, you can also update the firmware of the CIM 500
module and store or restore
To connect a PC to CIM 500, proceed as follows:
1. Connect the PC and the module using an ethernet cable.
2. Configure the ethernet port of the PC to the same subnetwork as CIM 500, for example 192.168.1.101.
See section How to configure an IP address on your PC using Windows 7
address on your PC using Windows
3. Open a standard Internet browser and type 192.168.1.100 in the URL field.
How to configure an IP address on your PC using Windows 7
1. Open "Control Panel".
2. Select "Network and Sharing Center".
3. Click [Change adapter settings].
4. Right-click and select "Properties" for the Ethernet adapter. Typically "Local Area Connection".
5. Select properties for "Internet Protocol Version 4 (TCP/IPv4)".
6. Select the "Alternate Configuration" tab and enter the user-configured IP address and the subnet mask you
would like to assign to your PC. See fig. 1.
Fig. 1 Example from Windows 7
How to configure an IP address on your PC using Windows 10
1. Search for "Ethernet" in Windows.
2. Select "Change Ethernet setting".
3. Select "Change adapter options".
4. Right-click "Ethernet" and select "Properties".
5. Select properties for "Internet Protocol Version 4 (TCP/IPv4)".
6. Select the "Alternate Configuration" tab and enter the user-configured
IP address and subnet mask you would like to assign to your PC.
184
settings, among other functions.
10.
or How to configure an IP
1