Connecting The Shielding Gas; Feed In Wire - Abicor Binzel MB EVO PRO Traducción Del Manual De Instrucciones Original

MB EVO PRO/MB EVO
4 Re-connect the return hose to the coolant recirculator.
4.5

Connecting the shielding gas

• Select the appropriate shielding gas for the welding task at hand.
• Briefly open the gas supply valve and close it again to blow out any
contamination at the connector.
4.6

Feed in wire

CAUTION
Risk of injury
Puncture or cut-in wounds may be caused by the wire electrode.
• Keep your hands out of the danger zone and wear the correct protective gloves.
1 Cut off a small piece of the start of the wire with a cutter to remove
any burrs.
2 Insert the wire in the wire feeder according to the manufacturer's
instructions.
5 Operational controls on the handle
NOTICE
• Consult the documentation for the welding components.
The button's two-cycle operating mode is available for the standard welding
torch.
5.1 Button with two-cycle function, fig. C
1 Press and hold button on handle = start welding.
6 Operation
1 Open the shielding gas cylinder, switch on the power source.
2 Set the welding parameters
7 Decommissioning
NOTICE
• Liquid-cooled cable assemblies leak if overheated. Therefore, allow the cooling unit to continue to run approximately 5 minutes after welding.
1 End welding.
2 Wait until the shielding gas post-flow time has passed and switch off the
power supply.
8 Maintenance and cleaning
DANGER
Risk of injury due to unexpected start
Turn off the entire system prior to assembling, disassembling or servicing parts of the device.
• Close all supply lines.
• Disconnect the electrical power supply.
WARNING
Risk of burns
The welding torches reach very high temperatures during welding.
• Allow the welding torches to cool down and wear the correct protective gloves.
8.1 Replacing wear parts, fig. F
• The torch neck can be fitted with various wear parts depending on the
welding task at hand.
• The gas nozzle and retaining spring are inserted.
• All other wear parts are screwed on.
5 Operational controls on the handle
• Connect the shielding gas to the welding device according to the
manufacturer's instructions.
• Adjust and set the amount of shielding gas for the gas nozzle in use and
welding task at hand.
3 Press the button to switch off power to the wire feeder until the wire exits
the contact tip.
4 Cut off any protruding wire.
Additional operating modes and handle modules depend on the power
source and must be purchased separately.
2 Release the button = end welding.
3 Start welding.
3 Close the shielding gas cylinder valve.
EN - 29