Rowenta DZ2120F1 Manual De Instrucciones página 13

PROBLEMS?
Problems
The iron is plugged
in, but the
soleplate of the
iron remains cold.
Thermostat
control light goes
on and off.
None or too little
steam is being
emitted.
Brown streaks
come through the
holes inthe
soleplate and stain
the linen.
Iron is leaking.
If you have any further problems or queries please contact our Custo-
mer Relations Team first for expert help and advice:
Helpline: 0845 602 1454 - UK / (01) 4610390 - Ireland
Or consult our web site: www.rowenta.co.uk
Cause
No mains supply.
Temperature control set
too low.
The automatic electronic
cut-out* is active.
This is normal.
Steam control set on dry
position .
Not enough water in the
water tank.
Residues in the steam
chamber or on the
soleplate.
Use of chemical descaling
agents.
Fabric fibres have
accumulated in the holes
of the soleplate and are
burning.
Your linen is not rinsed
sufficiently or you have
ironed a new garment
before washing it.
Use of starch.
Pure distilled /
demineralised or softened
water is being used.
Overuse of shot of steam
button.
Soleplate temperature too
low .
Solution
Check that the mains plug is
properly inserted or try plugging
the iron into a different socket.
Set the temperature control to a
higher temperature.
Move your iron.
When the thermostat control light
goes on and off the iron is heating
up. As soon as the thermostat
control light goes off the set
temperature has been reached.
Turn the steam control to the
required setting area.
Fill the water tank.
Use the Self Clean function then
clean your iron.
Do not add any descaling agents to
the water in the water tank. Use the
Self Clean function and clean your
iron.
Clean the soleplate with a
non-metallic sponge.
Vacuum the holes of the soleplate
from time to time.
Ensure linen is rinsed thoroughly to
remove any soap deposits or
chemicals on new garments which
may be sucked by the iron.
Always spray starch onto the
reverse side of the fabric to be
ironed and clean your iron soleplate.
Only use untreated tap water or mix
half tap water with half
distilled/demineralised water. Use
the Self Clean function and clean
your iron.
Allow more time between each
shot.
Set the temperature control to a
higher temperature.
Subject to modifications !
13
13
GB
F
I
E
P
GR
RF
UA
EST
LT
LV