Operators' Obligations; Year E1 Guarantee; Warranty - BWT E1 NEU 3/4-1 Instrucciones De Instalación Y De Servicio

EN

9. Operators' obligations

According to German legislation
You have purchased a durable and service-friendly
product. However, all technical plants require regu-
lar servicing to keep them in perfect working order.
The pre-requisite for functioning and the warranty is
the replacement of the filter element and the visual
inspection for leakproofness by the operator.
Verification of initial pressure every 2 months in the
case of zero flow and high levels of water removal.
A further pre-requisite for functioning and the warran-
ty is replacing wearing parts at the prescribed main-
tenance intervals (see '12. Maintenance instruction').
In accordance with DIN EN 806-5, wearing parts
must be replaced by experts (installer or factory ser-
vice centre).
We recommend entering into a maintenance con-
tract with your installer or factory service centre.
Note: Filters should not be operated by children.
Squeezing of the hand/fingers is possible.
Qualified staff:
The product may only be installed, commissioned
and serviced by skilled personnel. Only trained per-
sons are allowed to operate and use it.
Trained person:
Has received instruction and studied the information
in this document concerning the tasks entrusted to
him/her, and the possible risks in the event of inap-
propriate behaviour.
Skilled personnel:
Based on the professional training received, know-
ledge and experience, and knowledge of the rele-
vant definitions, is qualified to install the product, to
commission and to service it.
16

10. 10-year E1 guarantee

Depending on the BWT national subsidiary, a 10-
year guarantee is available for the new E1 filter.
The following prerequisites must be met:
- installation by a qualified expert
- proper operation
- registration (for details see www.bwt-service.com)

11. Warranty

In the event of breakdown during the warranty peri-
od, where a maintenance contract exists please con-
tact our factory service centre, specifying the type
of device (see technical data or type plate on the
device). Work under warranty may only be execut-
ed by our factory service centre. Works performed
under warranty by a specialist firm require explicit
commissioning by our customer service department.
If no maintenance contract exists, please contact
your in-house installer.