Sirius SL903-P Instrucciones De Uso Y De Montaje página 14

INSTALLATION
SL907
Before carrying out installation, please remo-
ve the grease filter in order to avoid possible
damages to the appliance. Please follow the
following steps to remove the metal grease
filter: open the lighted panel first, by turning
it downwards ( fig.1) , then remove the grease
filter by operating on its handle and making
the filter rotate downwards, disengaging it
from its seat.
Make a hole on the surface of the following
dimensions:
270mm x 498mm for SL907 52cm model
270mmx675mm for SL907 70cm model
Insert the SL907 unit, making sure the push‐
button panel is placed on the right , looking at
the product from the front of the cook‐top.
Make the electric connection and connect
the air‐outlet flange to a suitable exhausting
pipe.
Fix the unit by using the four screws provided
and tighten them as shown in fig. 16.
Insert the grease filter again and close the
perimeter panel.
WORKING
RC001
R C
ADIO ONTROL
Radio control used for the remote operation of duct-
ed cooker hoods.
T
ECHNI I CAL DATA
- Alkaline battery powered
- Operating frequency
- Combinations
- Max. consumption
- Operating temperature
- Dimensions
O D
PERATI I NG ESCRI I PTI I ON
The transmitter is equipped with 5 buttons for cook-
er hood management, as specified below:
: Light ON/OFF command.
: Motor ON (speed level 1) / OFF command.
: Reduce speed.
: Increase speed.
: 10-minute timer.
I O
NI I TI I AL PERATI I NG CONDI I TI I ON
The manufacturer supplies the radio control unit
ready to be used with codes preset in the Factory.
OPERATION MODE
Standard confi i gurati i on:
Standard configuration requires all "cooker hoods –
radio control - system" to be provided with the same
transmission code. In the event two cooker hoods –
radio control system are installed in the same room
or nearby, each system may affect the operation of
the another. Therefore, the code of one radio control
system must be changed.
Generati i ng a new transmi i ssi i on code:
The radio control system is provided with preset
codes. Should new codes be required, proceed as
follows: Press simultaneously buttons:
for two seconds. When Leds light on, press buttons:
14
(within 5 seconds). Leds flashing 3 times indicate
GB
: 12 V mod. 23 A
: 433.92 Mhz
: 32.768
: 25 mA
: -20 ÷ + 55 °C
: 120 x 45 x 15 mm.