Shindaiwa EB8510RT Manual Del Usuario página 7

Assembling the Blower (EB8510RT)
IMPORTANT!
This.unit.is.equipped.with.a.static..
discharge.reduction.wire..This.wire.helps.
direct.static.buildup.into.the.air.stream.
reducing.the.felt.amount.to.the.operator..
1. Place the blower upright on the ground
or a sturdy work surface and note parts
orientation as shown in Figure 7.
. Remove static wire from package and fix
eyelet to right hand engine cover screw.
See Figure 8.
3. Turn the discharge tube out to a right
angle and slip anti-static wire through
the 10mm clamp and flexible tube.
4. Install throttle cable holder just forward
of the 10 mm clamp, pinching loops
together to fit over end of flexible tube.
See Figures 10A and 10B.
5. Slip the flexible tube over the end of the
90° discharge tube, and secure with the
10 mm clamp.
NOTE:
Check to make sure that the 90° discharge
tube swivels freely. If any binding is present,
loosen 10 mm clamp and pull wire towards
engine to get more slack and recheck for
free movement.
6. Slide the throttle assembly over the
swivel tube. Do not tighten clamp at this
time.
7. Insert the static wire through the swivel
tube, then install and tighten the 89mm
clamp over the rotating band on the
swivel tube.
8. Fold the end of the static wire back over
the connection of the swivel tube.
See Figure 8.
9. Grasp the nozzle, and push the nozzle
over the swivel tube locking pins
securing the static wire. See Figure 9A.
10. Lock the nozzle to the swivel tube by
rotating the nozzle noting the alignment
marks. See Figure 9B.
11. Adjust throttle assembly for best
operator comfort and tighten two
socket-head screws.
Anti-Static
Wire
90° Discharge
Tube
102mm
Figure 7
Throttle
Assembly
Swivel
Tube
Throttle
Cable Holder
Static Wire
Static Wire
Connector
Figure 8
Loops
Figure 10A
Throttle Cable Holder
Figure 10B
Flexible Tube
Throttle
Cable Holder
89mm
Clamp
Clamp
Fold Wire
A
Flexible Tube
B
Figure 9
Blower.tube.installation.affects.blower.
performance! Make sure the tubes and
nozzle are correctly assembled per above,
and.that.all.connections.are.tight..Blower.
tubes.may.come.apart.during.use.unless.
tubes.are.aligned.and.locked.into.place..
Stop.the.engine.before.installing.or.
removing the blower tubes! Never
perform.any.maintenance.or.assem-
bly.procedures.on.this.unit.while.the.
engine is running!
Throttle
Assembly
Swivel
Tube
Long Nozzle
(ø74 mm)
Straight
Tube
Swivel Short Nozzle
Tube (ø65 mm)
Align the lock pins with the
lock slots, and push the tube
and nozzle together.
Lock Pin
Lock Slot
Rotate clockwise to lock
making sure the 3 lines
are aligned on both tube
and nozzle.
IMPORTANT!
WARNING!
Danger from rotating
impeller!
7