Epson SureColor F6070 Manual De Instrucciones página 3

| Replacing the Ink and Chip Unit
2
•
Gently tilt the ink pack when pouring ink into the ink tank.
•
Epson recommends the use of genuine Epson ink packs.
•
Epson cannot guarantee the quality or reliability of non-genuine ink. The use of non-genuine ink may cause
damage that is not covered by Epson's warranties, and under certain circumstances, may cause erratic
printer behavior.
•
Information about non-genuine chip unit status may not be displayed, and use of non-genuine ink is recorded
for possible use in service support.
•
Genuine Epson ink packs, other than those specified in this manual, could cause damage that is not covered
by Epson's warranties.
When the message
1.
ink pack to check how much ink is left in the ink tank.
If the remaining ink level is greater than 2.8 in. (70 mm) from the base of the ink tank:
Continue to use the printer until the remaining ink level is 2.8 in. (70 mm) from the base of the ink
tank so that you can use all the ink in a new ink pack to refill the ink tank.
If the remaining ink level is 2.8 in. (70 mm) or less:
Proceed to step 2.
Chip unit expended
is displayed on the control panel screen, use the scale on the