Tabla de contenido
Publicidad
3. FAN: Press the Fan button after starting the unit and adjust the desired fan speed.
4. TEMPERATURE - / TEMPERATURE +: Switch the unit into the cooling mode and use these buttons to adjust
desired room temperature (16-31° C).
5. SLEEP MODE: Switch the unit into the cooling mode and press this button to de- or activate the sleep mode.
6. TIMER: Turn the unit on and leave it in standby mode, then press this button to set the timer. You can set the
desired on or off time using the ▲ and ▼ keys (1h-24h).
Remote control
1. Power
2. Timer
3. Mode
4. Temperature +
5. Temperature -
6. Fan
7. Sleep mode
Functions
Cooling mode
•
After starting the unit it will automatically start with default settings: cooling mode, 22° C, low fan speed.
•
Press the MODE button to set the cooling mode, the cooling mode indicator lights.
•
Press the ▲ or ▼ to adjust to the temperature (16° C – 31° C).
•
Press the FAN button to adjust the fan speed (high or low).
Fan mode
•
Press MODE button to turn on the fan mode, the fan mode indicator lights.
•
Press the FAN button to adjust the fan speed (high or low).
•
Temperature setting and sleep mode cannot be set.
Timer
•
In standby mode, press the TIMER button to set the on-time. The timer indicator lights up.
•
After starting the unit press the TIMER button to set the off-time. The timer indicator goes off.
Dehumidifying mode
•
Drücken
Sie
Entfeuchtungsmodus-Indikator leuchtet.
•
Temperatureinstellung und Schlafmodus können nicht eingestellt werden, die Geschwindigkeit des
Ventilators bleibt automatisch niedrig.
Sleep mode
•
Press the SLEEP MODE button, the fan speed will be automatically adjusted on the low level.
•
If the sleep mode will be activated during operation in the cooling mode, the temperature will rise an
hour later by 1° C, two hours later by another 1° C and then remains constant.
•
Sleep mode is not adjustable during dehumidifying and fan mode. If the water tank is full, the standby
mode will switch on, settings will be deleted and the sleep mode will be disable.
Compressor protection
The compressor requires a start-up phase and will start three minutes later on after turning on / reboot
the device.
Important:
⑥
⑦
die
Taste
MODE,
⑤ ④
um
den
Entfeuchtungsmodus
③
②
①
einzustellen,
der
18
Publicidad
Tabla de contenido
