Remote Control - Suntec Wellness Klimatronic OFFICE 2.8 KW SUPERSILENT A+ A++ ECO Operación Manual

Automatic mode
•
After activation of this function, depending on the ambient temperature, the unit will automatically
determine which mode (cooling, heating or fan mode) is activated.
•
Please press the mode button on the remote control several times. While the automatic mode is active,
the display will indicate spinning bars:
•
Please set the desired fan speed (high, medium, low or automatic) with the fan button.
•
When your unit is only equipped with the cooling function, it will automatically switch to the fan mode as
soon as the ambient temperature is lower than 23 °C (73 °F) and return to the cooling mode as soon as
the ambient temperature is higher than 23 °C (73 °F).
•
When your unit is equipped with both the cooling as well as the heating function, the unit will automatically
switch to the heating mode as soon as the ambient temperature drops below 20 °C (68 °F). When the
ambient temperature is between 20 °C (68 °F) and 23 °C (73 °F), the unit will switch to the fan mode.
From 23 °C (73 °F), the unit will operate in cooling mode.
UV light:
•
This function is used to purify the air.
•
When the unit is in operation, press and hold the fan speed button "
UV light function. The "UV light indicator" appears on the display.
• Press and hold the fan speed button "
Note: The UV function is not available when the air conditioner is switched off.

Remote control:

The same settings can be performed using the remote control as with the control panel.
Powered by 2 x AAA batteries (not included)
WARNING - This unit contains a UV lamp.
Do not look into the light source.
On/off button
Mode button
Sleep mode (can only be
set via the remote control)
UP button
DOWN button
Please insert 2 "AAA" 1.5V batteries into the remote control to operate it.
" for 3 seconds to deactivate this function.
UV-C Lamp
Voltage: 12VDC
Wattage: 2W
" for 3 seconds to activate the
Fan speed
Timer
Temperature
Celsius/Fahrenheit
Swing (can only be set via the
remote control)
Function key
setting
21