Installation To Wood Stud Wall - PEERLESS SUF640P Instalación Y Ensamblaje

Installation to Wood Stud Wall

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-
ers are responsible to provide hardware for other types of mounting situations.
Wall plate (A) can be mounted to two studs that are 16" apart. Use a stud finder to locate the edges of the studs.
1
Use of an edge-to-edge stud finder is highly recommended. Based on their edges, draw a vertical line down each
stud's center. Place wall plate on wall as a template. The mounting slots should be located 7" (177 mm) above the
desired screen center as shown in figure 1.1. Level plate, and mark the center of the two mounting holes. Make
sure that the mounting holes are on the stud centerlines. Drill two 5/32" (4 mm) dia. holes 2" (51 mm) deep. Make
sure that the wall plate is level, secure it using two wood screws (C) as shown in fig. 1.2.
fig. 1.1
STUD
A
CeNTeR OF SCReeN
NoTe: If mounting with in-wall box model IBA1 (not UL listed), allow bottom edge
of wall plate (A) to touch top edge of in-wall box as shown below.
A
IN-WALL BOx
7"
(177 mm)
A
WooD STUD
WARNING
fig. 1.2
A
C
DRyWALL
WooD STUD
IN-WALL BOx
4 of 34
ISSUED: 05-29-08 SHEET #: 202-9281-4 03-31-09