Continental ContiPressureCheck Manual De Instrucciones página 57

Log iles
The log files that are created when working with the hand-held tool are stored in the
"REPORT" directory on the SD memory card (see Directory structure).
A unique name is automatically assigned to identify the individual log files. This is
made up as follows:
Code letter for the menu function
Vehicle name
executed
Max. 19 charac- T= Test drive / D = DTC / I = Installation
ters / V = "Check all tires"
* Serial no. and consecutive no. only appear when use of date/time is deactivated
in the menu Setup - Tool Properties - Date date.
►
A software program is off ered for evaluating the log files (see
www.contipressurecheck.com).
Handling the tool
In order to communicate with the tire sensors, the hand-held tool is equipped with an
antenna. The following describes the procedure for communication that is used in all
menus.
►
Always hold the antenna in the direction of the sensor in order to ensu-
re the best possible communication.
►
If sound and/or vibration was switched during setup, a corresponding
signal is emitted after successful reading.
►
The read operation takes place via 3 steps with increasing transmission
power. If communication beyond that is still not possible, the process is
aborted.
CPC hand-held tool
File name?
Date
(Serial no.)
YYYYMMDD
(XXXXXX)
Time
(Consecutive
*
no.)
*
hhmmss
(ZZZZ)
* *
57