Woods AD Serie Manual Del Usuario página 11

installation instruction
supplied with the appliance.
Always be careful when
you move the appliance
because it is heavy. Always
wear safety gloves.
Make sure the air can
circulate around the
appliance.
Wait at least 4 hours before
connecting the appliance
to the power supply. This is
to allow the oil to flow back
into the compressor.
Do not install the appliance
close to radiators or other
heat sources.
Do not install the appliance
where there is direct
sunlight. This device is only
for indoor use. Ensure that
the unit is placed on a
stable and flat surface. If
the surface is not stable
there is a risk that the unit
may be unstable and cause
excessive vibration and that
water will be released.
Electrical connection
WARNING
Risk of fire and electrical
shock.
The appliance must be
connected to a grounded
outlet.
Make sure that the electrical
information on the rating
plate matches the power
supply. If not, contact an
electrician.
Always use a correctly
installed shockproof socket.
English
Do not use multi-plug
adapters and extension
cables.
Make sure not to cause
damage to the electrical
components (e.g. mains
plug, mains cable).
Contact the Authorised
Service Centre or an
electrician to change the
electrical components.
The mains cable must stay
below the level of the mains
plug.
Connect the mains plug to
the mains socket only at the
end of the installation.
Make sure that there is
access to the mains plug
after the installation.
Do not pull the mains cable
to disconnect the appliance.
Always pull at the mains
plug.
Use
WARNING
Risk of injury, burns,
electrical shock or fire.
Do not change the
specification of this
appliance.
11
Be careful not to cause
damage to the refrigerant
circuit. It contains propane
(R290), a natural gas with a
high level of environmental
compatibility. This gas is
flammable.
If damage occurs to the
refrigerant circuit, make sure
that there are no flames and
sources of ignition in the
room. Ventilate the room.
Do not put flammable
products or items that
are wet with flammable
products near or on the
appliance.
Disposal
WARNING
Risk of injury.
Disconnect the appliance
from the mains supply.
Cut off the mains cable and
discard it.
The refrigerant circuit of this
appliance is ozone-friendly.
Contact your municipal
authority for information
on how to discard the
appliance correctly.
Do not cause damage to the
part of the cooling unit that
is near the heat exchanger.
Always see to that the
appliance is kept clean. Do
not cover the unit.