Product Description; Standard Compliance - Miller Honeywell SOLL WAPP Manual Del Usuario

The operator of the anchoring device must ensure that this manual:
• is stored in a safe, dry place near the anchoring device; or that it
• is always stored in an easily accessible place, which is known to all users.
The operator must produce this manual at the request of the manufacturer
(HONEYWELL FALL PROTECTION FRANCE SAS) or any of its licensees. Safety
regulations and rules for accident prevention must be complied with.
Anchoring devices must only be used for the intended purposes and cannot serve
as transportation or for lifting loads.
Confirm that the anchoring device that you have is in compliance with the
functions of other parts of the arrest system, and that the safety function(s) of the
individual components do not interfere with each other.
All equipment users must be in perfect health, and to ensure their safety must not
be under the influence of medication, drugs, or alcohol.
In the case that the product is sold outside its original designated country, for
the safety of the user, the seller must provide the following documentation in the
language of the country where the product is to be used:
• instructions for maintenance,
• instructions for regular inspections and tests
• any other requested information concerning the equipment
1-1 LIST OF INCLUDED PRODUCTS
See Technical specifications
1-2 MANUFACTURER CONTACT
Honeywell Fall Protection France SAS
35-37, rue de la Bidauderie
18100 VIERZON CEDEX - France
 IS.PPE.TECHSUPPORT.EUROPE@honeywell.com
 00 800 33 44 28 03
www.honeywellsafety.com

1-3 PRODUCT DESCRIPTION

FULFILS STANDARD EN 795:2012 TYPE A
1-4 COMPONENT COMPATIBILITY
Product performance, properties, and parameters are not guaranteed if different
components than those which have been approved and recommended for
anchoring equipment are used.
The anchoring device must be used exclusively with the following safety
equipment:
• fastening element fulfilling EN 362
• automatic retractable winches fulfilling EN 360
• fall-arresting harnesses fulfilling EN 361

1-5 STANDARD COMPLIANCE

This equipment has undergone CE test type EN 795:2012 type A by an authorized
entity, which has issued a a compliance certificate proving that the entire
equipment set and operating instructions are in compliance.
1-6 TERMS OF AND POSSIBILITIES FOR USE
Only safety gear compliant with standard EN 361 may be used with the fall arrest
system. Use only automatic pushers (EN 360) allowing for fall arrest that limit the
dynamic forces on the user to a maximum of 6 kN.
15