Miller Honeywell SOLL WAPP Manual Del Usuario página 18

After the fastening dries, screw a lifting eye to the threaded rod and proceed with a
traction test (500 daN over 15 seconds) and remove the lifting eye
Or implement the selected test method.
Install the anchoring and block it using the nuts provided.
RUPTURE OF THE LOAD INDICATOR
If the load indicator is broken (photo below):
If there was a fall or mechanical overload
- the anchoring must be replaced
- the resistance of the fastening point must be confirmed: screw a lifting eye on
the threaded rod and proceed with a traction test (500 daN over 15 seconds) and
remove the lifting eye
Install a new anchoring and block it using a prevailing-torque nut.
FALL INDICATOR:
The fall indicator (1) breaks at a force
of 450 daN. The 600 daN produced
by a fall are supported by section (1 and 2) .
2-5 INSTALLATION OF SÖLL
2-5.1 FIXING OF THE ANCHORING DEVICE ON A STEEL SUPPORT
• Screw with H M12 stainless steel A4 screw + 1 H M12 stainless steel A2 nut +
1 PAL M12 stainless steel A4 safety nut (see fig.5)
2-5.2 FIXING OF THE ANCHORING DEVICE ON A CONCRETE
fig.6)
• The plate is intended to be fastened with an HAS-R M12 110/28 anchoring
rod + 1 H M12 A2 nut + 1 PAL M12 stainless steel A4 safety nut + an HVU
M12x110 high performance chemical capsule
Choose a sound concrete support with a minimum strength of 23 MPa [3300
p.s.i.]
Drill a hole with a suitable masonry drill, A 14 mm, depth 115 mm.
The hole must be fully cleaned of dust in order to guarantee proper adhesion of the
chemical sealant.
The anchorage must not be less than 143 mm from the edge of the concrete
support
The anchorage must not be less than 165 mm from any other anchorage
Insert the resin or chemical plug, suitable for the concrete, in the hole.
Screw in the threaded rod with the aid of a power drill and that the chemical
compound is thoroughly mixed Leave the resin to dry for at least an hour (see
drying times) before handling it.
18
1
ANCRAGE VISION (1009975) Fig. 3
2
SUPPORT(See