Worx WU505 Manual De Instrucciones página 9

SYMBOLS
Read the manual
Warning
Do not dispose of batteries, Return
exhausted batteries to your local
collection or recycling point
1hour charging time
Inside use only
Do not expose to rain or water
Always charge the battery pack
between temperatures 0
Do not burn
Wear dust mask
Wear eye protection
Wear ear protection
Cordless Reciprocating Saw
13L-WU505-070305¸ÄFÓïCE´¦.indd 9
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
1. CHARGING YOUR BATTERY PACK
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because an electrical failure and hazard will
occur.
2. BEFORE USING YOUR CORDLESS
RECIP SAW
The provided battery pack is UNCHARGED
and you must charge it before use. You
battery pack will not develop its full capacity
until it has gone through several charge/
discharge cycles.
3. HOW TO CHARGE YOUR BATTERY PACK
Charging procedure
1) Plug the charger into an appropriate outlet.
2) Insert the battery pack into the charger ,
3) On completion of charge the red light (10)
Charging indicator
C to 30 C
o o
This charger is designed to detect some
problems that can arise with battery packs.
Indicator lights indicate problems (see table
below). If this occurs, insert a new battery pack
to determine if the charger is OK. If the new
battery charges correctly, then the original
pack is defective and should be returned to a
service center or recycling service center. If the
new battery pack displays the same problem
as the original Battery Pack, have the charger
tested at an authorized service center.
WARNING: The Charger and battery
pack are specifically designed to work
The red light (10) will flash for 1 second
and then go out.
the red light (10) will stay on to indicate the
charging process has started.
will change to continuous green.The pack
is now fully charged ,unplug the charger
and remove the battery pack (See A).
09
ENG
3/5/2007 4:43:45 PM