Environmental Protection - Worx WU505 Manual De Instrucciones

1. I CANNOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger
only in one direction.Turn the battery around
until it can be inserted into the slot, the red
LED light should turn on when the battery is
charging. (See F .1 and F .2)
2. REASONS FOR DIFFERENT CHARGING
TIMES.
Your charge time can be affected by many
reasons which are not defects in your product.
If the battery pack is only partly discharged
it may be re-charged in less than 1 hour. If
the battery pack and ambient temperature
are very cold then re-charging may take 1-1.5
hours. If the battery pack is very hot it will not
re-charge because the internal temperature
safety cutout will prevent it. If the green
light is illuminated but the red light will not
illuminate and the battery pack is hot then
this will be the problem and NOT a defect.
You must remove your battery pack from
the charger and allow your battery pack to
cool first to ambient temperature and then
12
re-charging can be started. If you charge a
second battery pack immediately after the first
then the charger can be overheated. Always
allow at least 15 minutes rest between battery
pack charging.
3. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES.
Charging time problems, as above, and
having not used a battery pack for a prolonged
storage will reduce the battery pack working
time.This can be corrected after several
charge and discharge operations by charging
& working with your saw. Heavy working
conditions such as cutting into hard wood will
use up the battery pack energy faster than
lighter working conditions. Do not re-charge
your battery pack below 0
as this will affect performance.
MAINTENANCE
Your tool requires no additional lubrication or
maintenance.There are no user serviceable
Cordless Reciprocating Saw
13L-WU505-070305¸ÄFÓïCE´¦.indd 12
All manuals and user guides at all-guides.com
parts in your tool, battery pack or changer.
Never use water or chemical cleaners to clean
your tool. Wipe clean with a dry cloth. Always
store your tool in a dry place. Keep the motor
ventilation slots clean. If you see some sparks
flashing in the ventilation slots, this is normal
and will not damage your tool.
ENVIRONMENTAL
PROTECTION
Check with your local authorities or retailer for
recycling advice.
PLUG REPLACEMENT(UK &
IRELAND ONLY)
If you need to replace the fitted plug then
follow the instructions below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
BLUE – NEUTRAL
BROWN – LIVE
As the colors of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows.The wire which
is coloured
blue must be connected to the terminal which
is marked with N.The wire which is coloured
brown must be connected to the terminal
which is marked with L.
Warning:
Never connect live or neutral wires to
o C and above 30 o C
the earth terminal of the plug. Only fit an
approved BS1363/A plug and the correct rated
fuse.
Note: If a moulded plug is fitted and has to
be removed take great care in disposing of the
plug and severed cable, it must be destroyed
to prevent engaging into a socket.
Waste electrical products must not be
disposed of with household waste.
Please recycle where facilities exist.
ENG
3/5/2007 4:43:46 PM