Canon SURE SHOT WP-1 Manual De Instrucciones página 34

E Questions and Answers
Can slide film be used with this camera?
Yes, it can, but use DX-coded film with a speed of
ISO 25, 50, 100, 200, 400, 800 and 1600.
What is ISO?
The ISO number indicates the film's sensitivity to
light in numerical terms. The higher the number, the
more sensitive to light the film is. For ordinary
photography ISO 200 or 400 film is recommended'
Q.3 Can films other than DX-coded films be used?
Yes, they can. ISO 25 film or non-DX-coded film are
not automatically taken up. Press the shutter button
until "1" appears in the frame counter. All non-DX-
coded film cartridges are automatically registered
as ISO 25.
What are the Parallax correction lines in the
viewfinder?
When taking close-up pictures (0.45m/1.Sft.),
compose your picture within these lines.
Q . 1
A . 1
Q . 2
4.2
A.3
Q . 4
A.4
64
65
Troubleshooting
Even if you think your camera may need repairs, check the table
below first. lf your camera still does not function properly after you
have made these checks, bring it to your nearest Canon service
facility for repairs.
Problem
Cause
Remedy
1 . T h e g r e e n
lamp doesn't
light up.
O The battery has expired
@ The battery is inserted
with the wrong polarity.
O Change the battery.
@ Reinsert the battery
correctly.
2. The shutter
doesn't
release.
O The mode selecting dial
is turned OFF.
@ The battery has expired.
@ The fllm is not inserted
properly.
@ A finished roll of film is
loaded in the camera.
O Turn the mode
selecting dial ON.
@ Change the battery.
@ Reload the film
correctly.
@ Remove the film and
load a new roll.
3. Pictures are
blurry.
O When lhe shutter was
released, the AF light
receptor was covered.
@ During self-timer
photography, you
pressed the selttimer
button while standing
immedialely in front of
the camera.
@ The camera was moved
when the shutler button
was pushed. (Camera
shake)
@ There were drops of
water on the lens.
0) Make sure the AF light
receptor is not covered
by hair, fingers, etc.
@ tvtake sure you are not
standing directly in
front of the camera.
@ Press the shutter
button lightly.
@ Use a dry, soft cloth to
wipe the lens before
taking a picture.
4. The back
cover does not
open.
The pressure inside the
camera is lower than the
surrounding pressure.
Unscrew the battery cover
using a coin. This should
equalize the pressure in
the camera and make it
easier to open the back
cover.