Special Safety Instructions For Sanding - Flex LLK 1503 VR Instrucciones De Funcionamiento Originales

LLK 1503 VR
 Keep bystanders a safe distance away
from work area. Anyone entering the work
area must wear personal protective
equipment.
Fragments of workpiece or of a broken
accessory may fly away and cause injury
beyond immediate area of operation.
 Hold power tool by insulated gripping
surfaces only, when performing an
operation where the cutting accessory
may contact hidden wiring or its own
cord.
Cutting accessory contacting a "live" wire
may make exposed metal parts of the power
tool "live" and shock the operator.
 Position the cord clear of the spinning
accessory.
If you lose control, the cord may be cut
or snagged and your hand or arm may
be pulled into the spinning accessory.
 Never lay the power tool down until the
accessory has come to a complete stop.
The spinning accessory may grab the surface
and pull the power tool out of your control.
 Do not run the power tool while carrying
it at your side.
Accidental contact with the spinning acces-
sory could snag your clothing, pulling
the accessory into your body.
 Regularly clean the power tool's air vents.
The motor's fan will draw the dust inside
the housing and excessive accumulation
of powdered metal may cause electrical
hazards.
 Do not operate the power tool near
flammable materials.
Sparks could ignite these materials.
 Do not use accessories that require liquid
coolants.
Using water or other liquid coolants may result
reesult in electrocution or shock.
Special safety instructions
for sanding
 Use only those sanding tools authorised
for use with your electric power tool and
the guard designated for this sanding
tool.
Sanding tools, which are not designated
for use with the electric power tool, cannot
be adequately shielded and are unsafe.
 Sanding tools may be used for the
recommended applications only.
For example: Never sand with the side area
of a diamond sanding pad.
Diamond sanding pads are designed to
remove material with the underside of the
sanding pad. If a lateral force is applied
to these sanding tools, they may shatter.
 Always use undamaged clamping flanges
in the correct size and shape for the inser-
tion tool you have selected.
Suitable flanges support the insertion tools
and therefore reduce the risk of a break.
 Do not use worn insertion tools from
larger electric power tools.
Insertion tools for larger electric power tools
are not designed for the higher speeds
of smaller electric power tools and may break.
15