Setting The Speed; Overload Protection - Flex LLK 1503 VR Instrucciones De Funcionamiento Originales

Continuous operation with engaged
switch rocker:
`^rqflk>
cçääçïáåÖ=~=éçïÉê=Ñ~áäìêÉI=íÜÉ=ëïáíÅÜÉÇJçå=
ã~ÅÜáåÉ=ïáää=ëí~êí=êìååáåÖ=~Ö~áåK
 Push the switch rocker forwards (1.) and
engage by pressing the front end (2.).
 To switch off the power tool, release the
switch rocker by pressing the rear end.

Overload protection

 If an extremely brief overload occurs,
the overload protection prevents damage
to the motor by automatically switching
the device off.
For further information on the manufacturer's
products go to www.flex-tools.com.
20

Setting the speed

To set the speed, move the dial to the required
value.
Operating instructions
klqb
tÜÉå=íÜÉ=ÉäÉÅíêáÅ=éçïÉê=íççä=áë=ëïáíÅÜÉÇ=çÑÑI=
áí ÅçåíáåìÉë=êìååáåÖ=ÄêáÉÑäóK
 Use the grinder particularly in areas which
are difficult to access, e.g. very acute inner
angles in railing construction.
 Do not place the sanding pad on the work-
piece until the power tool has reached full
speed.
 To obtain a good grinding result, move
the sanding pad evenly over the surface
which is to be ground down.
Do not apply excessive pressure.
 Use the profiline stone to obtain exact radii.
Pre-profile the grinding disc with it.
 When the power tool is switched off, the
grinding disc continues running briefly.
LLK 1503 VR