Kuppersbusch DW9350.0 Instrucciones De Uso página 17

Setting the clock
To set the clock, proceed as follows:
1) Press Alarm / Timer key twice.
2) Rotate the Timer/Clock knob to set the
hours.
3) Press Alarm / Timer key to confirm.
4) Rotate Timer/Clock knob to set the minutes.
5) Press Alarm / Timer key to confirm.
The display shows the clock for some seconds
and then switches off to reduce the power
consumption. The clock will be shown again for
a few seconds when the timer key is pressed in
standby.
Before carrying
maintenance activities,
extractor is disconnected from the mains.
To carry out cleaning and maintenance, follow
the Safety Instructions.
Fire risk exists in case that cleaning does not
take place according to the instructions.
Filter cleaning
To withdraw the filters from their locations
release the anchoring points. Clean the filter,
either by putting it in the dishwasher (see notes)
or leaving it standing in hot water to simplify the
removal of grease or, if wished, by means of
special sprays (protecting the non-metallic
parts). Once clean, leave it to dry.
Notes: cleaning in the dishwasher with
aggressive detergents may blacken the surface
of metallic parts, without this affecting its gas
retaining properties.
N.B. The filter must be cleaned at least once a
month depending on how often the extractor is
used. It must be remembered that grease is
deposited in the extractor when cooking,
whether it is switched on or not.
out any cleaning
ensure that
Program the working time
1) Switch on the cooker hood by rotating the
speed knob and choose the required
aspiration speed.
2) Press Alarm / Timer key.
3) Select the required programming time from 1
to 99 minutes by using the Timer/Clock
knob.
4) The display will show the remaining
programming time. The maximum speed
can only be selected manually and will be
changed automatically to the second speed
level after 7 minutes.
or
Cleaning of the extractor body
the
The use of warm (40ºC approx.) soapy water is
recommended. A cloth moistened in this water
is used for cleaning the extractor, paying
special attention to the grids. Afterwards, dry it
using a lint-free cloth.
Note:
 Never use metallic scouring pads or
abrasive products that could damage the
surface.
 Do not use scrapers with metallic surfaces
such as knives, scissors etc.
Activated charcoal filter
 To install the charcoal filter, the motor
anchorage is made to coincide with the
anchor points of the activated charcoal
filter and turn it clockwise.
 The carbon filter lasts from three to six
months depending on the particular
conditions of use.
 The activated carbon filter can neither be
washed nor regenerated. Once it is
exhausted, it must be changed.
english
17