Maintenance; Accessories; Technical Specifications - Senco DURASPIN DS522-18V Instrucciones De Empleo

Maintenance

Read section titled "Safety Warnings" before maintaining tool.
1. With battery removed, make daily inspection to ensure free movement of nosepiece and trigger. Do not use tool
if nosepiece or trigger sticks or binds.
2. Lubrication of the feed system is not necessary. DO NOT OIL.
3. Wipe tool clean daily and inspect for wear, especially the bit and nosepiece. Replace as necessary.
WARNING
Repairs other than those described here should be performed only by trained, qualified personnel.
Contact SENCO for information at +31 320 295 575.

Accessories

SENCO offers a full line of DuraSpin screws and accessories for your SENCO tools, including:
y Bits
y Batteries
y Battery Chargers
y Storage Bag
y Assorted Nosepieces
y Safety Glasses
For more information or a fully illustrated catalogue of Senco accessories, contact your sales representative or call Senco
at +31 320 295 575. www.senco.eu

Technical Specifications

SPECIFICATION
VOLTAGE
BATTERY AMPACITY
RPM 0-1600, 0-2500 REV/MIN
WEIGHT
HEIGHT
LENGTH
WIDTH
RECHARGE TIME
FASTENER CAPACITY
TORQUE DELIVERED
GENERATED NOISE
VIBRATION
FASTENER LENGTH
FASTER RANGE
DS522-18V
18V
3000MAH
2.48KG W/ BATTERY
243.5mm MAX
372.4mm MAX
85.4mm MAX
1 HOUR
50 SCREWS (1 STRIP)
8Nm MIN
84DB(A)
2.5M/S2 MAX
25mm - 55mm
3.5mm - 5.5mm
DS525-18V
18V
3000MAH
0-5000 REV/MIN
2.46KG MAX
243.5mm MAX
372.4mm MAX
85.4mm MAX
1 HOUR
50 SCREWS (1 STRIP)
5Nm MIN
84DB(A)
2.5M/S2 MAX
25mm - 55mm
3.5mm - 5.5mm
17
DS722-18V
18V
3000MAH
0-1600, 0-2500 REV/MIN
2.70KG MAX
243.5mm MAX
419.5mm MAX
85.4mm MAX
1 HOUR
50 SCREWS (1 STRIP)
8Nm MIN
84DB(A)
2.5M/S2 MAX
25mm - 75mm
3.5mm - 5.5mm
EN