Service; Screwdriver Safety Warnings; Safety Warnings For Charger And Battery - Senco DURASPIN DS522-18V Instrucciones De Empleo

30. Do not use a battery pack or tool that is damaged or modified. Damaged or modified batteries may exhibit
unpredictable behaviour resulting in fire, explosion or risk of injury.
31. Do not expose a battery pack or tool to fire or excessive temperature. Exposure to fire or temperature
above 130 °C may cause explosion.
EN
32. Follow all charging instructions and do not charge the battery pack or tool outside the temperature
range specified in the instructions. Charging improperly or at temperatures outside the specified range may
damage the battery and increase the risk of fire.

SERVICE

33. Have your power tool serviced by a qualified repair person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
34. Never service damaged battery packs. Service of battery packs should only be performed by the
manufacturer or authorized service providers.

Screwdriver Safety Warnings

1. Hold the power tool by insulated gripping surfaces, when performing an operation where the fastener
may contact hidden wiring. Fasteners contacting a "live" wire may make exposed metal parts of the power
tool "live" and could give the operator an electric shock.
2. Do not use the power tool in locations where the ambient temperature may reach 0°c (32°F) or exceed
40˚c (105˚F).

Safety Warnings for Charger and Battery

1. This manual contains important safety and operating instructions for the SENCO battery charger VB0192 (EU)/
VB0198 (UK). Use with approved Senco batteries stated on the charger label.
2. Before using the SENCO battery charger VB0192 (EU)/VB0198 (UK), read all instructions and cautionary
markings on (1) battery charger, (2) battery, and (3) product using battery.
3. Do not expose charger to water, rain or snow.
4. Use indoors.
5. Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire,
electric shock, or injury to persons.
6. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger.
7. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or
stress.
Table 1 - Recommended minimum AWG size for battery charger extension cords.
GENERAL POWER TOOL SAFETY WARNINGS
Length of Cord (Meters)
8m 15m
AWG Size of Cord
1.3mm 1.3mm
8
30m 46m
1.3mm 1.6mm