Menu Structure - Mtg2; Upgrading Your Gauge; Spares & Accessories - Elcometer MTG2 Guia Del Usuario

10 MENU STRUCTURE - MTG2

Menu
Calibration
Setup
About
Reset
Emergency Light

11 UPGRADING YOUR GAUGE

Gauge firmware can be upgraded to the latest version by the user
via ElcoMaster , as it becomes available. ElcoMaster will inform
the user of any updates when the gauge is connected to the PC with
an internet connection.
12 SPARES & ACCESSORIES
12.1 TRANSDUCERS
The transducers listed below are compatible with the MTG product
b
range . They are potted - the transducer cable is permanently fixed
to the transducer head - right angle, dual element, 'intelligent'
transducers and when connected, will be automatically identified by
the gauge.
The MTG2 is supplied complete with a 5.0MHz, 1/4" transducer
(TXC5M00CP-4). A transducer is not supplied with the MTG4 and
must be ordered separately. When choosing a transducer, the
frequency, diameter and material under test should be considered.
b
As the MTG2 is pre-calibrated for steel, only those transducers suitable for measuring on steel can be
used with this gauge.
en-11
R
Calibration
Zero Set
Setup
Units
Language
Beep Volume
Screen Settings
Gauge Auto Off
About
Gauge Information
Transducer Information
Contact
Legal
®
○
Units
mm
Inch
Screen Settings
Screen Brightness
Screen Timeout
Opening Screen
Legal
Legal Notices
Regulatory
○
○
○
Regulatory
®
www.elcometer.com
xxxxx
xxxxx