13 TECHNICAL SPECIFICATION (continued)
Model
e
Battery Lif
e
Gauge Weight
Gauge Dimensions
Can be used in accordance with: ASTM E 797, EN 14127, EN 15317
14 LEGAL NOTICES & REGULATORY INFORMATION
Declaration of Conformity: This product complies with the requirements of the following EU Directives:
2014/30/EU
Electromagnetic Compatibility
The Declaration of Conformity is available to download via:
www.elcometerndt.com/images/stories/PDFs/Datasheets/Declaration of Conformity/English/DoC_MTG2_MTG4.pdf
This product is Class B, Group 1 ISM equipment according to CISPR 11.
Class B product: Suitable for use in domestic establishments and in establishments directly connected to a low
voltage power supply network which supplies buildings used for domestic purposes.
Group 1 ISM product: A product in which there is intentionally generated and/or used conductively coupled
radiofrequency energy which is necessary for the internal functioning of the equipment itself.
The USB is for data transfer only and is not to be connected to the mains via a USB mains adapter.
The ACMA compliance mark can be accessed via: Menu/About/Legal/Regulatory
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
-- Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by Elcometer Limited could void the user's authority to operate the
equipment under FCC rules.
This Class B digital apparatus complies with CAN ICES-3 (B)/NMB-3(B).
and ElcoMaster are registered trademarks of Elcometer Limited, Edge Lane, Manchester,
R
M43 6BU. United Kingdom
All other trademarks acknowledged.
This product is packed in a cardboard package. Please ensure that all packaging is disposed of in an
environmentally sensitive manner. Consult your local Environmental Authority for further guidance.
Head-Office: Elcometer Limited, Edge Lane, Manchester, M43 6BU, United Kingdom.
e
When in continuous reading mode at a reading rate of 4 Hz, using alkaline batteries. Lithium or
rechargeable batteries may differ.
www.elcometer.com
MTG2
including batteries, without transducer
145 x 73 x 37mm (5.7 x 2.87 x 1.46")
®
Approximately 15 hours
210g (7.4oz)
without transducer
R
MTG4
en-16