Prepare The Site - Kohler K-2823 Manual Del Usuario

Support Brace
Two
Notches
Back Leg

1. Prepare the Site

NOTE: Assemble the pedestal on a clean, soft surface to avoid
damage.
NOTE: Assemble the pedestal upside down to ease assembly.
Identify the two back leg sections. Each leg has two notches at
the end of the support brace.
Identify the front leg. The front leg has one notch at the end of
the support brace.
Mark the front leg with masking tape.
Connect the retainer hub to one of the leg sections with a bolt.
Loosely tighten the bolt with a 1/4" hex wrench.
Connect the two remaining sections to the retainer hub with bolts.
Loosely tighten the bolts with a 1/4" hex wrench.
Thread a leg leveler into each leg.
Kohler Co.
Back Leg
Retainer
Hub
Leveler
Bolt
3
Masking
Tape
One Notch
Front Leg
1218951-2-B