Festool PLANEX LHS 225 EQ Manual De Instrucciones página 21

Problem
P L A N E X switches
off during work – red
LED on the head of
the machine fl ashes
P L A N E X does not
function
If other problems other than those listed occur, please contact your Festool service workshop or your
local specialist dealer.
Possible causes
Dust fi lter on P L A N E X clogged
Excessive pressure -> machine acti-
vates overheating protection
Sanding pad blocked – is not run in
after change of pad.
Electrical plug is not connected cor-
rectly.
Remedy
Clean the dust fi lter on the P L A N E X .
Allow the machine to cool and apply less
pressure; in extreme cases, switch on the
external extraction system and set the extrac-
tion control to setting 6.
Rotate sanding pad a few times by hand and
run in, also see chapter 7.3
Check that the electrical plug is inserted
properly.
21