Stanley FATMAX FMEG210 Manual Del Usuario página 6

ENGLISH
Kickback and related warnings
(Original instructions)
Regularly clean the power tool's air vents.
hazards.
materials.
Note:
Pinching or snagging causes rapid stalling of the rotating
at the point of the binding.
pinch point can dig into the surface of the material causing
operating procedures or conditions and can be avoided by
your body and arm to allow you to resist kickback
forces.
Always use auxiliary handle, if provided, for
during start-up.
Never place your hand near the rotating accessory.
Do not position your body in the area where power
tool will move if kickback occurs.
the point of snagging.
Use special care when working corners, sharp edges
etc. Avoid bouncing and snagging the accessory.
snag the rotating accessory and cause loss of control or
Do not attach a saw chain woodcarving blade or
toothed saw blade.
and loss of control.
6
cutting-off operations
cutting-off operations
Use only wheel types that are recommended for your
selected wheel.
designed cannot be adequately guarded and are unsafe.
The grinding surface of centre depressed wheels
must be mounted below the plane
of the guard lip.
adequately protected.
The guard must be securely attached to the power
tool and positioned for maximum safety, so the least
amount of wheel is exposed towards the operator.
could ignite clothing.
Wheels must be used only for recommended
applications. For example: do not grind with the side
of cut-off wheel.
may cause them to shatter.
correct size and shape for your selected wheel. Proper
Do not use worn down wheels from larger power
tools.
for the higher speed of a smaller tool and may burst.
Do not "jam" the cut-off wheel or apply excessive
pressure. Do not attempt to make an excessive depth
of cut.
Do not position your body in line with and behind the
rotating wheel.
you.
When wheel is binding or when interrupting a cut for
any reason, switch off the power tool and hold the
power tool motionless until the wheel comes to a
complete stop. Never attempt to remove the cut-off
wheel from the cut while the wheel is in motion
otherwise kickback may occur.
Do not restart the cutting operation in the workpiece.
Let the wheel reach full speed and carefully re-enter
the cut.