EdilKamin BIJOUX Instalación Uso Y Mantenimiento página 49

Should this correction not suf ce, contact the Edilkamin-
authorised Dealer, to establish the new operating axis.
Notes on ame variability:
ame depend on the type of pellets used, as well as on normal
variation of solid fuel ames and on the periodic cleaning of
the crucible the boiler-stove automatically carries out
(Note: This does NOT replace the necessity cold vacuuming by
the user prior to start up).
Environmental temperature control
this comfortable and simple adjustment feature, as standard in
this line of products, allows you to manage the stove power
based on the environmental temperature.
After activating the "Comfort Clima" function from the para-
meters menu (ask the technical assistance centre - TAC), press
the SET button brie y a couple of times to switch from classic
"Modulate_Power" mode to "Comfort Clima" mode; then
select the desired mode from the display.
Modulate power mode
the stove modulates its power by following the output tempera-
ture set by the user.
Comfort Clima mode
the stove modulates its power by following the output tempe-
rature set by the user. You can also use the remote control as a
room thermostat: on reaching the set temperature the stove will
go to minimum power.
Setting the environmental temperature
In "Comfort Clima" mode, by pressing the +/- buttons on the
synoptic panel or on the remote control, you can set the display
to the desired environmental temperature.
-At environmental temperatures below the set temperature, the
stove modulates power normally to reach the set output.
-With environmental temperature reached (+2°C), the stove
goes to minimum power.
The environmental temperature is transmitted from the remote
control; the remote control transmitter must be visually aligned
with the receiver of the synoptic panel
If the remote control is incorrectly positioned, it cannot send
its recorded temperature. The stove therefore independently
decides to operate at minimum power and continues thus until
the connection with the remote is restored
Temperature control with external thermostat
another temperature control system is available as an alterna-
tive to the remote control. You can in fact connect the thermo-
stat serial port to your home thermostat or any (clean output
contact) easily available one
The stove will automatically recognise the connection with the
thermostat serial port under the following conditions:
With environmental temperature lower than the thermostat
setting (contact closed), the stove modulates power normally to
reach the set temperature
-With environmental temperature reached by the thermostat
(contact open), the stove goes to minimum power
INSTRUCTIONS FOR USE
Any changes in the state of the
Temperature
Con guration provided by the
remote control
"Comfort
Clima" ON
parameter
"SONDA IR"
ON
parameter
Connection to NO
serial port no connection
- 49
-
Temperature
provided by
No adjustment
external
(factory setting)
environmental
thermostat
ON ON
OFF ON
Yes
NO
with blue
no connection
serial cable