KTM Power Parts 60112092150 Manual De Instrucciones página 5

Scope of delivery
1x GPS mounting adapter 60112092050
Assembly
First remove the side trim panels (1). To do so, remove the screws marked
on both sides of the vehicle.
1
5
Pull the lamp unit out of the fixing sockets (2), undo the cable
connections and take off the lamp unit.
2
Position the upper holding bracket of the mounting adapter in the cockpit
and mark the holes to be drilled with a pencil. Remove the cockpit trim.
Drill two holes in the cockpit trim at the marked positions with a 13 mm drill
bit. Debur the holes with a suitable tool.
55 mm
NOTE:
Each hole should be located in the center of the raised section.
Screw the lower holding bracket onto the cockpit plate using the supplied
M6x16 screws, U-washer and self-locking nuts. Tighten the screws only
lightly so that the holding bracket can still be shifted. Mount the cockpit
trim.