KTM Power Parts 60112092150 Manual De Instrucciones página 6

Apply the rubber buffer plug (1) to the upper holding bracket. The upper
holding bracket can be attached and shifted in different locations. This
lets the rider move the GPS device to the position that is best suited for
him or her.
1
1
6
Place both distance bushings (2) through the holes of the cockpit trim and
onto the lower holding bracket (3). Place the upper holding bracket (4) onto
the distance bushings and fix it using the M6x30 screws. Tighten the screws
only lightly. Now align the two brackets. First tighten the screws of the lower
holding bracket, followed by those of the upper holding bracket.
4
2 2
3
The GPS bracket can now be mounted on the cross pipe of the upper hol-
ding bracket. Reconnect the cable connections of the lamp unit, and mount
the lamp unit and the side trim panels.
(A) GPS bracket 2
(B) GPS bracket 1
A
B