Suntec Wellness Klimatronic heat Block PTC Instrucciones De Uso página 8

 Do not use the heater with a programmer or timing
device that switches it on automatically. The use of
such devices is dangerous and can cause a fire risk.
 When switched on for the first time a slight odor might
be emitted for a few minutes. This is harmless and
occurs with most heaters when any slight traces of
dust or lubricants that may have collected in the
factory are heated away.
SYMBOL FUNCTION
"OFF" OFF
"FAN" Fan only, no heat
"I" Low heat output
"II" Full heat output
Thermostat:
Turn clockwise to increase the heat output.
Operation:

Plug the heater into a suitable power outlet [observing all the instruction regarding positioning and switch on.
To use the fan only function:

Turn the control dial to "FAN". The fan will blow out air at room temperature.

If the fan does not operate, the ambient room temperature is cooler than the built-in thermostat "OFF" level.
Turn the thermostat dial gradually clockwise and the fan will start blowing.

As soon as the fan starts, the light in the front of the machine will illuminate.
To use the machine for heating:

Turn the control dial to "I" for low heat and "II" for full heat.

Set the level of heat by turning the thermostat dial gradually clockwise for the lowest heat and fully clockwise
for maximum.

The thermostat will turn the machine off when the selected room heating is achieved, and when the
temperature drops it will turn on again automatically.

For maximum heat output use "II" with the thermostat turned fully clockwise.

To distribute heat evenly around a room, press "SWING" button.
Overheating:

The thermostat will turn the machine off it overheats.

Overheating can be caused by obstruction to the air intakes on the back of the machine or the grill on the
front. If this occurs please disconnect the machine and allow it to cool for 30 minutes. Remove any
obstruction and turn the machine back on.

If the heater ceases to function, the most likely cause is a blown fuse. Please bring the heater to your market
for any services.
Cleaning and care:

There are no parts inside the machine that require your attention or servicing. Do not try to open the outer
case. By doing so you could damage the motor and heating element and invalidate the warranty. If you have
a problem with the heater, or if the power cord gets damaged in any way, you MUST take the unit to a
suitably qualified engineer or electrical repair centre.

Before cleaning the machine, please make sure it is disconnected from the power supply, and has cooled
down completely.

Never cleaning the machine, please make sure it is disconnected from the power supply, and has cooled
down completely.

Never clean the machine with water and do not let it get wet under any circumstance.

The outside case and be cleaned using a slightly damp lint-free cloth [a small amount of detergent can be
used if required].