Blackmagic Design URSA Manual Del Usuario página 32

Settings
32
Display settings screen with Zebra set to 100%. This will let
you see which areas of your image are over exposed.
SDI Overlays set to All with the HDTV frame guide. Your
selected overlays can be viewed independently via URSA's
10" fold out monitor, touch screens and SDI outputs. Press the
Disp button on the fold out monitor to independently cycle
through the SDI overlay setings on the fold out monitor.
All manuals and user guides at all-guides.com
10" Brightness
Move the 10" Brightness slider icon left or right to adjust brightness for the 10" fold out monitor.
Zebra
To activate and adjust the Zebra setting, tap the left and right zebra arrow icons.
The Zebra helps you achieve optimum exposure by displaying diagonal lines over areas of the video
that exceeds your set zebra level. For example, setting the zebra to 100% shows which areas are over
exposed. Setting the zebra to 75% is helpful for achieving optimum exposure for skin tones.
Simply open the lens aperture until the zebra pattern appears, then gradually close the aperture until
the zebra pattern disappears. To achieve optimum exposure, you may need to decide which areas of
your picture to leave over exposed. Car headlights and extreme highlights are a good example of what
can often be left over exposed.
SDI Mode
Use this setting to switch Blackmagic URSA's 12G-SDI output between 4K and HD video.
Overlay Settings
You can monitor your video with overlays via the fold out monitor and touch screens, or by connecting
an external viewfinder or display to URSA's 12G-SDI output or HD-SDI Monitoring Out connector.
To choose an overlay to display, tap the overlay setting arrow icons:
Off: gives you a clean feed.
Status: displays only the recording information, such as f-stop number, frame rate and shutter angle.
Guides: displays only the frame guides.
All: displays both frame guides and recording information.
5" LCD Overlays
Select On or Off to enable or disable a touch screen's overlays.
Main SDI Overlays
This setting lets you choose which overlays to display via Blackmagic URSA's 12G-SDI output.
Front SDI Overlays
This setting lets you choose which overlays to display via the HD-SDI monitoring output.