Blackmagic Design URSA Manual Del Usuario página 43

Upgrading the Sensor Turret
43
Removing the Sensor Turret
Step 4.
Remove the 15mm rails mount using the 4.0mm
hex key driver.
Step 7.
Remove all four screws and lift the sensor turret.
All manuals and user guides at all-guides.com
Step 5.
Loosen the four sensor turret mounting screws two
full turns using the 4.0mm hex key driver.
Step 8.
As you lift the turret, the adjoining data connector
will be released from the camera chassis.
Step 6.
Use the plastic wedge levering tool to lever the
sensor turret loose from the camera body.
Step 9.
Remove the thermal gap pads from the large and
small copper block using the plastic wedge levering
tool. Thoroughly clean the copper blocks in the
camera chassis and the sensor turret with the lint
free cloth. Do not use any cleaning fluids.