Kit Assembly - Metra 99-7357HG Instrucciones De Montaje

1. Remove (2) screws from each vent,
attach them into the radio trim
panel, and then secure using the
same screws.
2. Remove (4) panel clips and then
attach them onto the radio
trim panel
3. Attach the pocket to the radio
brackets using the (2) supplied
#8 x 3/8" Phillips screws. (Figure A)
4. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
5. Slide the radio into the bracket/
pocket assembly and then secure
with the screws supplied with
the radio. (Figure B)

Kit Assembly

(Figure A)
99-7369B
6. Locate the factory wiring harness
and antenna connector in the
dash and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Test the radio for
proper operation.
7. Secure the completed assembly into
the dash using the factory screws.
8. Snap the radio trim panel over
the completed assembly and then
reassemble the dash in reverse
order of disassembly.
3
(Figure B)