MAAX 107223 Instrucciones De Instalación página 11

Panel Installation
WARNING
Fumes Hazard
The fumes from the silicone and solvents used
by the installer can be harmful if used in an
unventilated room. Always work in a well-ventilated area.
To keep the area well-ventilated, open windows and use
exhaust fans. If adequate ventilation is not achievable or
practical, use respiratory protective equipment.
1. Clean the backs of each panel with denatured alcohol or
another non oil-based cleaning solvent.
IMPORTANT NOTICE
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the panel
from adhering properly to the wall.
2. Apply the silicone in 1-1/4" diameter dots every 8 to 10
inches apart over the surface of the panel. Follow the
silicone manufacturer's instructions and note all ventilation
and installation precautions.
Corner
Alcove
BK-PI-002b
11
3. Corner: Install left-hand panel (1) first. Then, install right-
hand panel (2).
Alcove: Install back panel (1) first. Then, install left-hand
panel (2). Finally, install right-hand panel (3).
2
1
4. Firmly press the surface of each panel against the wall. It
is important to apply hand pressure to the entire surface of
the panel to bond it to the wall surface.
Installation Procedure
1
2 3