MAAX 107223 Instrucciones De Instalación página 13

4. Insert small blocks between the front-to-rear panel braces
and the back panel braces. These will apply pressure to
the back panel to hold it in place.
5. Remove the braces after 24 hours.
Corner Molding (if applicable)
Installing the corner molding is optional. If the panels were
scribed and cut to create a tight-fitting corner, then the corner
molding can be eliminated. If, however, there are gaps
between the front/rear panel, the corner molding should be
installed. Either option, if done properly, is acceptable.
If the optional soap dish was installed, cut one piece of molding
to fit above the soap dish and one for below the soap dish.
Note: Either clear or color matched silicone can be used to
install corner molding strips.
1. Measure and cut the corner moldings to length.
2. Dry fit the corner molding.
WARNING
Fumes Hazard
The fumes from the silicone and solvents used
by the installer can be harmful if used in an
unventilated room. Always work in a well-ventilated area.
To keep the area well-ventilated, open windows and use
exhaust fans. If adequate ventilation is not achievable or
practical, use respiratory protective equipment.
3. Clean the surface of the panels and the back of the molding
with denatured alcohol or another non-oil based solvent.
13
Installation Procedure
BK-CM-001b
BK-CM-002