Zamel MOLIK ST-66 Manual Del Usuario página 3

GB
wireless Battery operated chime moliK st-66
• The device is ideal as a doorchime, an internal calling device or a personal alarm device,
• Useful at home, at a company, and for people who need care,
• The doorchime installation in not needed,
• The chime is powered with three R14 1.5 V batteries,
• Radio transmission (433,92 MHz operating frequency),
• Operating range*: 50m in open area,
• A possibility of setting an individual user's code-64 codes to select,
• The push-button is not adapted to changeable weather conditions,
• It is possible to increase the number of the chimes and push-buttons, if needed,
• Two sounds to select-a possibility of identification of the call location,
• DING-DONG sound or Westminster Abbey chimes sound,
• Volume: 76 dB,
• The transmission optical indicator built in the push-button.
technical data
moliK chime
Receiver-the chime:
Power supply: R14 1.5V alkaline battery x 3
Transmission: radio
Operating frequency: 433.92 MHz
Coding: 64 codes
Operating range*: 50m
Volume: 76 dB
Degree of IP Protection: IP 20
Protection class: III
Temperature operating range: 0°C ÷ 35°C
Overall Dimensions: 90 x 140 x 36 mm
Power consumption: 20 mA max
st-66p pUsh-BUttoN
Transmitter-the remote control
Power supply: MN21 / 23A 12 V battery
Transmission: radio
Operating frequency: 433.92MHz
Transmitter power output: <5mW
Coding: 64 codes
Operating range*: 50m
Optical indication of transmission
Degree of IP Protection: IP 20
Overall Dimensions: 41 x 72 x 19 mm
* The given operating range is for open area, under ideal conditions, with no obstacles. If there are any obstacles
between the transmitter and receiver one should expect the operating range decrease as follows: for wood and gypsum:
by 5-20%, for bricks: by 20-40%, for reinforced concrete: by 40-80%. It is not recommended to use RF systems within
the presence of some metal obstacles because of substantial operating range decrease. Power transmission lines,
either air or underground, and GSM transmitters close to the equipment have a negative effect on the operating range.
assemBly iNstrUctioN maNUal
1. General description
The chime may be used as a doorchime, an internal calling device or a personal alarm device.
In case of ST-66 chime the doorchime installation in not needed.
The kit includes MOLIK chime and ST-66P wireless push-button.
The chime and the pushbutton are battery operated.
433.92 MHz frequency is used for signal transmitting and receiving.
The MOLIK chime operating range reaches 50m in open area.
There are 2 various chime sounds to select. Owing to this fact it is possible to recognize which push-button is the source
of signal when many remote controls are being used with this receiver.
A single chime may interoperate with the unlimited number of the remote controls, and -in turn-a single remote control
may interoperate with any number of the chimes.
2. interoperation of the chime and the remote control
In order to make the chime and the remote control interoperate it is necessary to keep the following rule: the code
jumpers of the chime and the push-button must be set identically.
6 push-button jumpers and the first 6 chime jumpers are designed for the code setting (refer to the figure).
Note! Please, remember to set the chime and the remote control jumpers identically!
The push-button is not adapted to changeable weather conditions.
3. the sound selection
There are two sounds to select: DING-DONG sound or Westminster Abbey chimes sound imitation, Westminster bells
are factory set.
In order to change the sound type it is necessary to change the position of the jumper inside the chime, jumpers 7 and
8 (refer to the figure).
the declaration of conformity is on our website www.zamelcet.com