Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3¼" X 10"
HORIZONTAL
KNOCKOUT
PLATE
15 DUCTED INSTALLATION ONLY:
Remove 3¼" x 10 vertical, 3¼" x 10" horizontal, or 7-inch
round knockout plate(s) as appropriate for your ducting
method.
TOP/BACK
EDGE OF
HOOD
7" ROUND
DUCT
PLATE
16
DUCTED INSTALLATION ONLY:
Attach 3¼" x 10" Damper/Duct Connector (if using 3¼"
x 10" duct) or 7" Round Duct Plate (if using 7-inch round
duct) over the knockout opening.
Notes:
To accomodate off-center ductwork, the 3¼" x 10"
damper/duct connector can be installed up to ½" on either
side of the hood center and the 7" round duct plate can
be installed up to ½" on either side of the hood center.
Install the 3¼" x 10" Damper/Duct Connector with the
Damper Flap Pivot nearest the Top/Back Edge of
Hood.
7" ROUND
KNOCKOUT
PLATE (also
remove 3¼" x 10"
vertical plate)
3¼" X 10"
VERTICAL
KNOCKOUT
PLATE
3¼" X 10"
DAMPER /
DUCT
CONNECTOR
DAMPER
FLAP
PIVOT
INSTALL THE HOOD
WARNING
To reduce the risk of electrical shock, switch power off
at service panel. Lock or tag service panel to prevent
power from being switched on accidentally.
ELECTRICAL
POWER
CABLE
KNOCKOUT
17
Remove Electrical Power Cable Knockout from top or
back of hood.
Run House Power Cable between service panel and hood
18
location. Attach power cable to hood using appropriate clamp.
19
Hang hood from (4) mounting screws driven part-way into
cabinet locations (shown in illustrations under "PREPARE
HOOD LOCATION"). Mounting screws are included in parts
bag. Slide hood back towards wall until mounting screw
heads are engaged in narrow end of keyhole slots in top of
hood. Tighten screws securely. Add 5th mounting screw in
center hole in hood and tighten securely.
DUCTED INSTALLATION ONLY:
20
Connect ductwork to hood and use duct tape to make joints
secure and air-tight. Make sure the damper / duct connector
enters the ductwork and that the damper opens and closes
freely.
CBX1 SERIES
Page 5
HOUSE
POWER
CABLE
Publicidad
Tabla de contenido
