Front View - PEERLESS PARAMOUNT PPF Manual Del Usuario

Attaching Adapter Plate to Projector Mount (continued)
Attach adapter plate (C) to projector using one screw (H, I, J or K)
4
for each channel as shown. Tighten all screws, while keeping the
adapter plate centered. Be sure that adapter plate and pivot/roll
bracket (B) are in the correct position. Adjust the feet of the chan-
nels to keep the adapter plate level. Tighten all screws with 4 mm
security allen wrench (M) while keeping the center of gravity. If M3
screws (H) are used, place washer (L) between screw and foot of
channel and tighten using 2 mm security allen wrench (N).
Note: Projectors will require different size screws for mounting.
Use a combination of screws (H, I, J or K) and foot adjustment
that will result in channels of adapter plate (C) fitting tightly against
projector. Important: In order to properly engage the threads in
the mounting holes, the screw must be turned at least 3 full turns.
• It is the responsibility of the installer to ensure that
the projector is properly ventilated. Feet of channels
are used to raise the mount off the projector surface.
Thread two M5 x 10 mm screws (F) into top holes of hanger bracket of
5
swivel assembly (A), leaving 1/8" (3 mm) exposed thread between head
of screw (F) and hanger bracket as shown in figure 5.1.
guide hook slots of pivot/roll assembly (B) onto M5 x 10 mm screws (F)
in swivel assembly (A) as shown in figure 5.2. Fasten two socket pin
screws (F) through slots in pivot/roll bracket and into swivel assembly as
shown in figure 5.3.
• Do not lift more weight than you can handle. Use ad-
ditional man power or mechanical lifting equipment
to safely handle placement of the projector.
fig. 5.2
HOOk SLOTS
Visit the Peerless Web Site at www.peerlessmounts.com
CAUTION
WARNING
B A
F
fig. 5.3
7 of 24
H, I, J or K
fig. 5.1
F
HANger
BrACkeT
1/8"
(3 mm)
FrONT vI eW
ISSUED: 12-26-07 SHEET #: 055-9496-2 10-16-08
For customer care call 1-800-865-2112 or 708-865-8870.
C
F
1/8"
(3 mm)
A
F