Attaching Adapter Plate To Projector Mount; Top View - PEERLESS PARAMOUNT PPF Manual Del Usuario

Attaching Adapter Plate to Projector Mount

guide flanges of pivot/roll bracket (B) under flanges of adapter plate (C) by rotating 90° as shown in figure 2.1.
2
Secure pivot/roll bracket (B) to adapter plate (C) by using two M5 x 10 mm screws (F) and two locknuts (G) as
shown in figure 2.2.
B
fig. 2.1
FLANgeS
Using 4 mm security allen wrench (M), loosen the eight screws
3
on adapter plate (C) (shown in figure 3.1) one full turn to allow for
adjustments of channels.
Place projector upside down and locate mounting holes. If there are
only three mounting holes remove fourth channel from adapter
plate. Center adapter plate (C) over the center of gravity of the pro-
jector while aligning mounting holes on channel feet with mounting
holes on projector as shown in figure 3.2 and figure 3.3.
Note: Be certain hook slots of pivot/roll bracket (B) face to the
back of the projector as shown in figure 3.3.
Important: If projector does not have at least three mounting holes,
do not use this adapter plate.
fig. 3.2
Visit the Peerless Web Site at www.peerlessmounts.com
FLANgeS
C
generic Projector

TOP VIEW

F
fig. 2.2
B
G
fig. 3.1
fig. 3.3
Channel
Channel
Foot
Mounting
Hole
C
6 of 24
ISSUED: 12-26-07 SHEET #: 055-9496-2 10-16-08
For customer care call 1-800-865-2112 or 708-865-8870.
Hook slots face to the
back of projector
B
C
C
Loosen one full
turn for channel
adjustments