Switching The Unit On - Renfert SILENT TS2 Guia De Inicio Rapido

Connection
⇒ Connect to the compressed air supply system, using a connection kit if necessary (17, Fig. 1).
Observe the minimal / maximum connection pressure, see technical data!
Compressed air should be clean and dry (without condensed water). Wet compressed air can
damage the unit.
⇒ Shorten the suction pipes for both extraction points to the required length with a knife.
⇒ Screw the PVC end bushings onto the suction pipes (left handed thread).
Caution: risk of injury!
When shortening the suction pipe please ensure to cut at a right angle.
⇒ Fit suction hose (18) in intake socket (15) and connect to suction point.
Long suction hoses, tight bends and kinks will considerably reduce the extraction force at the
extraction point.
⇒ Electrical appliances can be connected to the coupler sockets (9, Fig. 1) at the back of the unit. Check
the connections are correct - coupler socket (A, B) - suction hose / pinch valve (A, B).
When connecting electrical appliances to the extraction unit, please ensure that the power con-
sumption of all devices connected to the unit power outlet does not exceed the total maximum
power for connected equipment (see "tech. Data").
⇒ Insert the mains cable into the plug socket.
Operation

Switching the Unit On

The extractor is put into operation at the on / off switch (3).
Stand-By
In the stand-by mode the display is dark.
Leave stand-by mode:
• Press any button
• Switch on any electrical appliance connected to the extractor.
Once switched on, the suction hose will open immediately and the extractor turbine will activate.
Select vacuum channel
Start / stop suction turbine and open / close corresponding
pinch valve valve:
• Automatically:
The electrical appliance connected to the coupler socket
(9, Fig. 1) is activated / deactivated.
• Manually:
By pressing a suction hose button (39).
Adjust suction power
MENU
Set the extraction force:
• Button (43), increases extraction force.
• Button (41), reduces extraction force.
MENU
A B
B
A
OFF
ON
A B
B
A
- 3 -
OFF
ON
OFF resetdefault
MENU
A
A
39
41 43
EN
3
ON
B
B