Information For The Purchaser; Application; Correct Use Of The Unit; Unapproved Use - Renfert Millo Manual De Instrucciones

The following information is intended to
help purchasers ensure safe operation of
the Millo / Millo pro in their laboratory.
Instruct operators on the appli-
cation, possible hazards during
use and operation of the arch
trimmer based on the user infor-
mation.
Ensure that this user information is avail-
able to operators.
A. Application
A.1 Correct use of the unit
Only use the unit for trimming dental stone
or resin dental arches
A.2 Unapproved use
Only spare parts and accessories supplied
or authorized by Renfert GmbH may be
used with this product. If other spare parts
or accessories are used, this could have
a detrimental effect on the safety of the
device, increase the risk of serious injury
and lead to damage to the environment or
the device itself.
A.3 Ambient conditions
(according to DIN EN 61010-
1)
The unit should only be operated:
• indoors
• up to 2,000 metres above sea level
• at an ambient temperature of
5 ºC - 40 ºC [41 ºF - 104 ºF] *)
• at a maximum relative humidity of 80 %
at 31 ºC [87.8 ºF], linear reduction up
to 50 % relative humidity at 40 ºC
[104 ºF] *)
• with mains electricity supply provided
that the voltage fluctuation is within 10 %
of the rated value

Information for the purchaser

• with Pollution Degree 2
• with Overvoltage Category II
*) The unit can be used at a temperature of
5 ºC - 30 ºC [41 ºF - 86 ºF] and at a humidity
of up to 80 %. At temperatures of 31 ºC - 40 ºC
[87.8 ºF - 104 ºF] the humidity must reduce propor-
tionately to ensure that the unit can be operated
(e.g. at 35 ºC [95 ºF] = 65 % humidity, at 40 ºC
[104 ºF] = 50 % humidity). The unit should not be
operated at temperatures above 40 ºC [104 ºF].
B. Hazards and warnings
Granted protection is not given
any longer in case the unit is
not operated according to the
instruction manual on hand.
Only to be used indoors. The
unit is only intended for dry op-
eration and should not be used
or stored outdoors or in wet
conditions.
The unit should only be oper-
ated using a mains cable with
a country-specific plug sys-
tem. Any modification required
should only be carried out by an
electrician.
The unit should only be operated
if the data on the rating plate
corresponds with the data of
regional mains voltage.
The unit should only be plugged
into earthed sockets.
The mains socket should be
easily accessible.
Regularly check connecting
cables and hoses (e.g. mains
cable) for damage (e.g. kinks,
tears, porosity) or deteriora-
tion. Do not operate units with
damaged mains wires, hoses or
other defects.
- 7 - EN