Midi Implementation Chart - Marshall DSL100HR El Manual Del Propietario

REAR PANEL FUNCTIONS (CONT.)
33. LOUDSPEAKERS
There are five speaker outputs available.
They are labelled according to the
intended impedances:
• 1 x 16 Ohm: connect a single 16 Ohm
speaker cabinet to this jack.
• 1x 8 Ohm or 2 x 16 Ohm: connect a
single 8 Ohm speaker cabinet or two
16 Ohm speaker cabinets.
• 1 x 4 Ohm or 2 x 8 Ohm: connect a
single 4 Ohm speaker cabinet or two
8 Ohm speaker cabinets.
ENGLISH
WARNING: Although the amplifier has five
speaker outputs, never attempt to connect
more speaker cabinets than rated. The safe
combinations are: 1 x 16 Ohm, 1 x 8 Ohm, 2 x
16 Ohm, 1 x 4 Ohm or 2 x 8 Ohm only. Any other
speaker cabinet configuration may stress the
power amplifier section and in extreme cases may
lead to valve and/or output transformer failure.
NEVER use DSL100HR or DSL40CR without a
speaker load.

MIDI IMPLEMENTATION CHART

1. BASIC INFORMATION
MANUFACTURER: Marshall MODEL: DSL 40 & DSL 100
VERSION: 1.1
FUNCTION TRANSMITTED RECOGNISED REMARKS
MIDI Channels N
Note Numbers N
Program Change N
Bank Select Responce
Modes Supported:
Mode 1: Omni-On, Poly
Mode 2: Omni-On, Mono
Mode 3: Omni-Off, Poly
Mode 4: Omni-Off, Mono
Multi Mode
Note-On Velocity N
Note-Off Velocity N
Universal System Exclusive N
Manufacture System Exclusive N
2. MIDI TIMING AND SYNCHRONIZATION
FUNCTION TRANSMITTED RECOGNISED REMARKS
MIDI Clock N
MIDI IMPLENATION CHART CONTROL NUMBER INFORMATION
MANUFACTURER: Marshall MODEL: DSL 40 & DSL 100
VERSION: 1.1 DATE: 24.08.17
FUNCTION # TRANSMITTED RECOGNISED REMARKS
13 N
14 N
ENGLISH
Y (1-16) Default receive channel 1
N
Y (0-127) Amp channels mapped to
every four PC values
N
N
N
N
N
N
N
N
N
N
N
Y LOOP
0 = Off
1 = On
2-127=Toggle State
Y Master
0 = Off
1 = On
2-127=Toggle State