Washing Instructions - Össur DH Manual Del Usuario

tape or gauze from foot. Scything hex edges like as shown in
picture 5 to prevent the hexes from falling into the relief zone.
For open-toe option: Place foot inside the shoe, heel first. Position
6.
ankle strap pad such that it is centered over foot. Fasten the ankle
strap and flaps. Ankle strap pad slides along the length of the ankle
strap. The strap needs to be centered correctly to protect the foot
from the ankle strap. Trim excess strap length.
7. For closed-toe option (Steps 7 through 8): Lift front section of
insole from outsole of shoe. Insert toe piece onto front of insole.
Make sure there is no gap between front of insole and inside of toe
piece. Do not remove entire insole from the shoe to keep the
orientation of the offloading.
8. Insert foot into shoe, toe first. Fasten ankle straps and flaps. Center
the ankle strap pad for extra cushioning. Tongue should be
positioned under the ankle strap in order to provide cushioning.

WASHING INStrUCtIoNS

Wash shoe and insole separately.
1. Remove insole from shoe. Rinse the insole with gently flowing 86F
(30˚C) warm water.
2. Wash shoe by hand using mild soap, a damp cloth or sponge, and
86F (30˚C) warm water. Do not remove any additional hexes. Do
not use alcohol or solvents. Do not put in washing machine or
immerse shoe in water.
3. Insole should be air dried. To speed drying, a hair dryer can be
used on the low setting.
4. When the pad is fully dried, re-insert into the shoe. Always follow
fitting instructions when re-inserting the insole into shoe.
6