GYS BATIUM 25/24 Manual Del Usuario página 14

Translation of the original instructions
Speciic to the IUoU mode
Once the charge is inished, the charger is in loating mode
self sicharge .
Speciic to the IUIo mode
Nb : The batium does not switch to loating mode once the charge is over. If the battery stays connected afer the end of charge, every
72h, the batium 25/24 performs a charging cycle to compensate for self-discharge.
Speciic to «SOS Recovery» mode
• Once the battery is desulfated, the Batium resumes a regular IUoU charge.
• If it does not succeed in recovering the battery, the display shows «out»
9. When the battery is charge (green
110. Disconnect the power supply cable.
11. Disconnect the clamps / or the battery connector.
In the event of a power cut, the BATIUM saves the state of charge (except in « SOS Recovery » mode), and resumes the charge using the latest
settings.
« SOS RECOVERY » FUNCTION
This mode is for deeply discharged batteries (Anomaly 2, table p.8).
After connecting the battery, the Batium analyses the battery state of health: display
If after 1 minute, the « SOS Recovery » indicator lashes, this means that the battery is sulfated (due to a long deep discharge).
The « SOS Recovery » uses a speciic curve to perform a 24h recovery cycle.
To activate this feature, follow these steps :
1.Disconnect the battery from the vehicle. (OVERVOLTAGE DANGER)
2.Connect the Batium to the battery.
3.Connect the Batium to the mains then position the switch to «ON».
4.Select the IUoU charging curve.
5.Activate the feature by pressing the «SOS recovery» button for 5 seconds until the indicator (p.5) switches on.
6.Choose the charging voltage and the charging speed.
7.Do not touch anything for a few seconds, the desulfation process starts.
FORCED CHARGE FUNCTION
In the event of a deeply discharged battery (voltage inferior to 2 V), the Batium does not start the charge and signals it :
• The dipslay's leds rotate
• The indicators « battery voltage », « capacity » and « charging curve » are switched on.
To force the charge, press the button 2 for 5 seconds , until the Batium displays CHE (check). The charger detects a battery with a
voltage above 0.5 V (± 0,3 V).
Like other modes, this step is made of 2 phases :
1. A diagnostic phase (battery voltage analysis).
Nb : For 12 or 24 V batteries, during this phase, the Batium detects a deeply discharged battery and suggests a 6 V charge. To
conirm or correct this voltage (12 or 24 V), rapidly press the button 2 (before the Batium starts the charge) (Anomaly 6 p.8).
2. A recovery phase (voltage rises). If the Batium does not succeed in recovering the battery, it stops after 30 minutes.
The veriication step (CHE) inished, the Batium starts a normal IUoU charge. For further details about the charge process, refer to
«Connections and general operations»-.
PROTECTIONS
The Batium 25-24 is protected against short-circuits and polarity reversals. It has an anti-spark feature which prevents sparks whilst
connecting the device to the battery. The device will not deliver current if there is no battery detected (no voltage in the clamps).
14
BATIUM 25/24
: it can remain connected to the battery and compensates for the
.
indicator), position the switch to « OFF ».
.
EN