Assembly / Disassembly - Fama TV ÉLITE Manual De Instruccion

ELECTRICAL FEEDING
The electrical feeling connection must be in conformance with the legislation relevant to the state in which is used.
The electrical feeding must so be maintained in conformance with the following technical prescriptions:
1. the electrical feeding must be always of the type and have an intensity corresponding to the specifications listed in the
machine plate. If excessive voltages are applied, some components will be damaged irreparably,
2. a differential device must be foreseen coordinated with the protection circuit, respecting the legislation and the actual
legislative and prescribed disposals in the operative installation country;
3. the cable for the electrical feeding outside the machine container, must be made pass in the spaces prepared from
You and adequately protected;
4. if present the neutral cable (N) before to feed the electrical equipment, as for you must be guaranteed its continuity
(connected and available).
5. before to feed the electrical equipment, as for you must be guaranteed its continuity (connected and available) of the
yellow green cable of the protection equipotential circuit.

ASSEMBLY / DISASSEMBLY

The assembly / disassembly operations of any machine member are performed with the stopped machine
and with the plug disconnected to the socket, or with the sectioning device in OFF.
The tools assembly on the machine performs in different phases.
1. Slacken the block knob (1) of
the superior closure cover (2)
and remove it from its position
(supported to the machine body
3) with the use of both the
hands;
2. On the rotating hub, insert for
the first the expeller disc (4),
checking that the drag pivots
presented on the hub connect in
the holes on the discs;
3. Having to perform workings that
request the use of an only disc,
connect on the hub the rotating
disc (5) over the expeller disc
(4) (cfr. Tables of the chapter n.
2)
4. Having to perform working that
request the contemporary use
of two discs, connect on the
rotating hub in sequence the
following elements: (cfr. Tables
of the chapter n. 2)
1° - Expeller disc (4)
2° - Fixed disc (6)
3° - Rotating disc (5)
5. Place the cover (2)
6. in the machine superior zone
and tighten the block knob (1).
VEGETABLE PROCESSOR
ORIGINAL INSTRUCTIONS TRASLATION
Pag. di
10 17