Turning On Your Monitor - Angelcare AC315 Manual Del Usuario

STEP 4 - TURNING ON YOUR MONITOR
Your Camera Unit and Parent Unit come pre-paired.
ON
OFF
1
1
When Parent Unit is turned ON and Camera is OFF, Parent Unit will display
Out-of-Range icon.
If there is a lost connection between the two units after 15 seconds, the Out-of-Range alarm will sound on
the Parent Unit (refer to Troubleshooting section):
•
INFO BAR IMPORTANT ICONS
Camera displaying
Wired
image and sound
Sensor Pad
Normal Status
Sensor Pad
is Paused
Sensor Pad
Alert
Sensor Pad Lost
Link
4.1 - HOW TO SET THE DATE
When activating the Parent Unit for the first time, you'll be asked to set the date and time in order to record
movement & temperature data. If you choose to skip this step, you can always go back later by accessing the
settings menu .
3
02:04 68°F
12/31/2016 31/12/2016
/ /
08 22 2016
4
1) Slide the Camera ON/OFF switch to the ON position.
1) Press and hold the Parent Unit ON/OFF button for
2 seconds until LCD screen is turned ON. Angelcare's logo will be
shown for 1 second.
The Out-of-Range icon will appear on the screen and on the info bar.
"TIC" icon
VOX icon
1
1) Press
Year display.
2) Press the down arrow
3) Set the day with the up/down arrows
Do the same for the month and year and confirm with
4) Press the down arrow
highlighted in blue then Press the
2
The Camera connection signal strength icon will
appear in the status bar.
Reception
Quality icons
Temperature
alerts icons
Too Cold
Too Warm
Out-of-Range
to switch between Month/Day/Year and Day/Month/
once and then
, the Save icon at the bottom is
Volume Level
icons
Battery Level
indicators
Fully charged
battery (only
appears when
Parent Unit is
plugged in
to set the date.
and confirm with
.
button to save the settings.
E
N
.
9