Guidance And Manufacturer's Declaration - Electromagnetic Emissions - Etac R82 HB40 Manual De Instrucciones

Guidance and manufacturer's declaration - electromagnetic emissions

The Product is intended for use in the electromagnetic environment specified below. The customer or the
user of the product should assure that it is used in such an environment.
Emissions test
EN
RF emissions
CISPR 11
RF emissions
CIPSR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/ flicker
emissions
IEC 61000-3-3
Electromagnetic compatibility (EMC) environ-
ment
This equipment is for use in home healthcare facility
environment.
This equipment is not likely to cause any harmful
interference in nearby equipment; however, it can
be impaired by electromagnetic (EM) interference
emitted by other equipment, which can lead to
malfunctions. Do not use this equipment where
there is a risk that other electrical and/or electronic
equipment can interfere with this equipment.
This equipment complies with the following
standards
IEC 60601-1-2:2014 Medical electrical equipment
- Part 1-2: General requirements for basic safety
and essential performance - Collateral Standard:
Electromagnetic disturbances - Requirements and
tests (EN 60601-1-2:2015)
EN 12182:2012, Clause 7, Assistive products for
persons with disability – General requirements and
test methods
Compliance
Group 1
Class A
Class B
Complies
EMC - WARNINGS
Use of this equipment adjacent to or stacked with
other equipment should be avoided because it
could result in improper operation. If such use is
necessary, this equipment and the other equipment
should be observed to verify that they are operating
normally.
Use of accessories, transducers and cables other
than those specified or provided by R82 could
result in increased EM emission or decreased EM
immunity of this equipment and result in improper
operation. Several power plugs are supplied with
this equipment. Please use the correct power plug
suitable for your country. Please chose among
the supplied power plug adaptor units: English,
Australian, EU, US/Japanese plugs.
Portable radio frequency (RF) communication
equipment (including peripherals such as antenna
cables and external antennas) should be used
no closer than 30 cm (12 inches) to any part of
the product, including cables specified by R82.
Otherwise, degradation of the performance of this
equipment could result.
Electromagnetic
environment - guidance
The Product uses RF energy only for
its internal function. Therefore, its
RF emissions are very low and are
not likely to cause any interference
in nearby electronic equipment.
etac.com
4