Operating Instruction For Battery And Electrodes; Battery; Disposal Of Battery; Connected Electrodes To Lead Wires - Hydas 4509.1.00 Instrucciones Servicio

4 | Operating instruction for battery and electrodes

4.1 | Battery

a
Slide the battery compartment cover
b
While removing the battery, just slightly pick up the belt under the battery compartment.
c
Insert the 3 units of AAA 1.5V batteries into the battery compartment. Be sure to match the positive
and negative ends of the battery to the marking in the battery compartment of the device.
d
After replacing the battery, make sure compartment cover to be tightly closed.

4.1.1 | Disposal of battery

• Spent batteries do not belong in the household waste.
• Dispose of the battery according to the current regulations.
• As a consumer, you are obligated by law to return spent battery to the Recycle Bin
Caution!
• If a battery has been swallowed please seek medical attention immediately!.
• Increased risk of leakage, avoid contact with skin, eyes and mucus membranes. Rinse the affected spots
with lots of clear water immediately and contact a physician right away.
• Battery may not be dismantled, thrown into fire or short-circuited.
• Protect battery from excess heat.
• Take the battery out of the product if they are spent or in case you no longer use the article. This prevents
damage caused by leaking battery
• Replace all of the batteries simultaneously!
• Always replace the same type battery

4.2 | Connected electrodes to lead wires

Insert the lead wire connector into electrodes connector. Make sure they are
properly connected to ensure the good performance. (Please refer to pic. 1)
Caution!
Always use the electrodes with the requirements of the IEC/EN60601-1 ,ISO10993-1/-5/-
10 and IEC/ EN60601-1-2, such as with CE mark, or which are legally marketed in the US under 510(K)
procedure.

4.3 | Connect Leadwires to device

Before proceeding to this step, be sure the device is completely turns OFF.
a
The wires provided with the system insert into the jack sockets located on top of the device. Holding
the insulated portion of the connector, push the plug end of the wire into one of the jacks one or two
sets of wires may be used.
b
This device has two output circuit at the top of the unit controlled by Channel A and Channel B. You
may choose to use one channel with one pair of lead wires or both channels with two pairs of lead
wires. Using both channels gives the user the advantage of stimulating two different areas at the
same time.
Caution!
Do not insert the plug of the lead wire into any AC power supply socket.

4.4 | Electrode

• The electrodes are disposable and should be routinely replaced when they start to lose their adhesive
nature. If you are unsure of your electrode adhesive properties, please order new replacement electrodes.
• Replacement electrodes should be re-ordered through or on the advice of your physician the manu-
facturer of the device to ensure proper quality.
• Follow application procedures outlined in electrode packing, to maintain optimal stimulation and to
prevent skin irritation.

4.4.1 | Place elektrodes on skin

Apply electrodes to the exact site indicated by your physician or therapist. Before applying electrodes,
be sure the skin surface over which electrodes are placed is thoroughly cleaned and dried. Make sure the
electrodes are placed firmly to the skin and make good contact between the skin and the electrodes.
• Inspect your electrodes before every use. Replace electrodes as needed. Reusable electrodes may cause
slight skin irritation, lose adhesion and deliver less stimulation if overused.
20
and open it.
13
Pic.1